Showing 1 to 20 of 20 (1 Pages)
Any manicure cutter is used only for one stage of hardware processing of the nail plate. This is due to the fact that each nozzle has its own relief, which allows you to use it in individual cases. You can't do all the work with just one device. Therefore, there are several types of attachments.
Advantages of ceramic cutters
For the production of this type of cutter, a special abrasive composition is used as the initial raw material, baked on the adhesive. This allows you to increase the service life by 4 times, in comparison with solid-alloy products. They wear very little, so you don't have to buy them often. Corrosion is also not terrible, unlike metal cutters. An important point is that these cutters are fragile, so you need to work them carefully.
Ceramic cutters are not as hard as diamond ones, but they are also versatile in use. Due to their abrasiveness and diverse structure, they Polish the surface much faster and better.
To evaluate the advantages of a ceramic cutter, it is enough to apply them to the processing of artificial coatings, in particular, shellac or gel varnish. Usually, the master uses for these purposes removal fluids that destroy cell fat and dry the nail plate. This leads to the fact that the nail gradually becomes thinner, then begins to break and layer.
Ceramic cutters are used in such cases without soaking, which makes it possible to preserve the natural strength of the nail. The cutter gently removes the old layer, and in the case of shellac – grinds the soft layer, while not clogged with dust, unlike other types of nozzles.
It is no secret that novice masters may not be accurate and inexperience cause discomfort to their clients. Ceramic cutters are the best option for starting manicure classes. They do not blunt for a long time, and practically exclude the possibility of damage to the nail or skin coating. Especially such nozzles are suitable for medical pedicure. The ceramic itself heats up slowly, so there is no need to stop frequently during the working process to allow the nozzle to cool down.
Ceramic cutters are virtually free of dirt, so they often do not need to be cleaned from dirt and dust. This allows you to speed up the process of working with the client. This nozzle can be used for wet and dry treatment, and the gel Polish is removed in 10 minutes.
Ceramic cutters are easy to clean and can withstand the use of disinfectants. It is enough to soak them for 4-5 hours, then dry them and warm them up in the oven. If there is an autoclave, drying is not necessary.